Product testing

Star services build global

sample testing

As the authoritative testing cycle of insulating glass is too long, it is suggested that customers should make a simple test before mass production. The specific details are as follows:
1、Take 10 pieces of 200 x 400mm single glass
2、Operate normally according to the operating process of warm packing material.
3、Put the insulating glass sample into place naturally for 48 hours.
4、Cold water soaking: place the glass sample into the cold water tank for 100% soak for one week.
5、Take out the glass sample after soaking in cold water and put it at room temperature for 24 hours. Then, after naturally boiling for 2 hours, check if seal failure occurs.
Note: the above is a simple and convenient method for users to test by themselves. It cannot be used as the basis of terminal test.